Broil Element; Rtd Sensor - Viking RDSOE306SS Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.

Broil Element

1. Open oven door.
2. Remove screws securing broil element.
3. Slide broil element into cavity and disconnect
wiring.
4. Repair or replace broil element as necessary.
5. Reverse procedure to reinstall.
© 2012 Viking Preferred Service

RTD Sensor

1. Open oven door.
2. Remove screws securing sensor and cover to
oven cavity.
3. Slide sensor into oven cavity and disconnect
wiring.
4. Repair or replace RTD sensor as necessary.
5. Reverse procedure to reinstall.
49