Siemens SIMATIC Box PC 620 Manual page 99

Primary Master Primary Slave Secondary Master/ Secondary Slave
The system jumps to the following submenu when you select this type of menu
field:
Main
Primary Master [4326MB]
Type:
Cylinders:
Heads:
Total Sectors
Maximum Capacity
Multi-Sector Transfers:
LBA Mode Control:
32 Bit I/O:
Transfer Mode:
Ultra DMA Mode:
F1 Help
ESC Exit
Figure 6-3 Primary Master
"Type" Field
The parameters you can select here are usually stored on the IDE drive. The 'Auto'
setting in the 'Type' field means that these values are automatically read from the
drive and written into memory (Autodetect).
If Type is selected for a drive that cannot be detected, a timer times out in
approximately 1 minute and the entries remain unchanged. You should always
check that the interfaces for which you select 'Auto' are in fact connected to drives.
Select "User" if you want to define the hard-disk type yourself, in which case
remember that you also have to set the other fields, including Cylinder, Heads,
Sectors/Track and WritePrecomp, to the correct values for the type of hard disk in
question.
SIMATIC Box PC 620 Manual
C79000-G7076-C639-04
PhoenixBIOS Setup Utility
[Auto]
[8940]
[ 15]
[8448300]
4326MB
[16 Sectors]
[Enabled]
[Enabled]
[FPIO 4 / DMA 2]
[Disabled]
Select Item + / – Change Values
Select Menu Enter Select Sub-Menu
Configuring the SIMATIC Box PC 620
Item Specific Help
[AUTO] (recommended)
Autotypes installed
IDE-devices
[USER]
Enter parameters of
IDE-devices installed
at this connection
F9 Setup Defaults
F10 Save and Exit
6-7