Siemens SIMATIC Box PC 620 Manual page 78

SIMATIC Box PC 620 Expansions
Aligning the Holding-Down Device
Proceed as follows to install the holding-down device.
1. Insert the slide element through the guide slit until it is resting firmly on the
module. The module must now be introduced into the notch.
Caution
!
No pressure may be exerted on the module! Therefore, do not use force to press
the slide element onto the module.
2. Cut off the projecting part of the slide element:
– Score the slide element at the top edge of the holding-down device with a
knife and break it off.
– Nip off the surplus with a sharp side cutter.
5-16
SIMATIC Box PC 620 Manual
C79000-G7076-C639-04