Siemens SIMATIC Box PC 620 Manual page 51

Caution
!
Before plugging in or taking out Cardbus/PC cards, you must discharge the
electrostatic of your body by briefly touching grounded object (ESD guidelines,
Section A.1).
Otherwise faults can occur.
Note
Surge currents of 650 mA at 5 V relating to 3 s are allowable!
Examples of PCMCIA cards connected to PC card interface for
Installing PC Cards
Note the following when installing these cards:
Note
Depending on the configuration of the SIMATIC Box PC 620, there may not be any
free interrupts available for operating PC Cards. You have to reserve the necessary
PC card interrupts in the BIOPS setup menu as follows:
Set the necessary interrupt via Advanced > PCI-Configuration >
PCI/PNP ISA IRQ Resource Exclusion to "reserved" (default: available).
SIMATIC Box PC 620 Manual
C79000-G7076-C639-04
Setting Up and Operating the SIMATIC Box PC 620
Hard Disk
(Maxtor MXL-131-III) . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
Fax/modem . . . . . . . . . . . . . . . .
(Dr. Neuhaus) . . . . . . . . . . . . . .
Ethernet
(XIRCOM) . . . . . . . . . . . . . . . . .
330 mA read/write
640 mA spin up 2 s
110 mA idle
60 mA idle
140 mA transfer
150 mA
4-11