Siemens SIMATIC Box PC 620 Manual page 102

Configuring the SIMATIC Box PC 620
Option "Boot Options"
The following submenu appears when you select the option "Boot Options" in the
main menu:
Main
QuickBoot Mode:
SETUP prompt:
POST Errors:
Floppy check:
Summary screen:
F1 Help
ESC Exit
Figure 6-5 "Boot Options"Submenu
Quick Boot
Mode
SETUP prompt
POST Errors
6-10
PhoenixBIOS Setup-Utility
Boot Options
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
Select Item + / – Change Values
Select Menu Enter Select
Some hardware tests are skipped to speed up the boot procedure.
The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter "Disabled"to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.
Item Specific Help
Allows the system to skip cer-
tain tests while booting. This
will decrease the time needed
to boot the system.
F9 Setup Defaults
Sub-Menu F10 Save and Exit
SIMATIC Box PC 620 Manual
C79000-G7076-C639-04