Additional References - Cisco Catalyst 4500 series Administration Manual

Additional References

The static route on SwitchB exists solely to enable the BFD session between 10.201.201.1 and
Note
10.201.201.2. If there is no useful static route to configure, select a prefix that will not affect packet
forwarding, for example, the address of a locally configured loopback interface.
Additional References
Related Documents
Related Topic
Cisco IOS commands
Configuring and monitoring BGP
Configuring and monitoring EIGRP
Configuring and monitoring OSPF
BFD commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
BGP commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
EIGRP commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
OSPF commands: complete command syntax,
command mode, command history, defaults, usage
guidelines, and examples
Standards
Standard
IETF Draft
IETF Draft
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)SG
39-28
Chapter 39
Document Title
Cisco IOS Master Commands List, All Releases
Cisco BGP Overview" module of the
Configuration Guide
"Configuring EIGRP" module of the
Configuration Guide
"Configuring OSPF" module of the
Configuration Guide
Cisco IOS IP Routing: Protocol-Independent Command Reference
Cisco IOS IP Routing: Protocol-Independent Command Reference
Cisco IOS IP Routing: Protocol-Independent Command Reference
Cisco IOS IP Routing: Protocol-Independent Command Reference
Title
BFD for IPv4 and IPv6 (Single
Bidirectional Forwarding
Configuring Bidirection Forwarding Detection
Cisco IOS IP Routing Protocols
Cisco IOS IP Routing Protocols
Cisco IOS IP Routing Protocols
Hop), February 2009
Detection, February 2009
OL_28731-01