Genie ZX-135/70 Service And Repair Manual page 178

Service and Repair Manual
Fault Codes
Error Source
Left Front Steer Angle
Sensor
Right Front Steer Angle
Sensor
Left Rear Steer Angle
Sensor
166
Error Type
Value at 5.0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too High Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too Low
Value at 0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value at 5.0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too High
Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too Low
Value at 0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value at 5.0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too High Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Value Too Low
Value at 0 V Primary up, Secondary up/down and
Extend disabled, Alarm sounds
ZX-135/70
Effects
Check for an open ground circuit going
to the sensor
Sensor is out of range. Check sensor
and actuating pin for proper installation.
Repair or replace sensor and
recalibrate.
Check for 5.0 VDC at the sensor.
Check for damaged wiring going to the
sensor. Check that the % .0 VDC LED
is lit on the TCON board. Repair or
replace as necessary
Check for an open ground circuit going
to the sensor
Sensor is out of range. Check sensor
and actuating pin for proper installation.
Repair or replace sensor and
recalibrate.
Check for 5.0 VDC at the sensor.
Check for damaged wiring going to the
sensor. Check that the % .0 VDC LED
is lit on the TCON board. Repair or
replace as necessary
Check for an open ground circuit going
to the sensor
Sensor is out of range. Check sensor
and actuating pin for proper installation.
Repair or replace sensor and
recalibrate.
Check for 5.0 VDC at the sensor.
Check for damaged wiring going to the
sensor. Check that the % .0 VDC LED
is lit on the TCON board. Repair or
replace as necessary
October 2016
Recovery Actions
Part No. 1268558