Commissioning The Application - Siemens MICROMASTER 440 Operating Instructions Manual

3 Functions
3.5.5

Commissioning the application

After the motor – drive inverter combination was commissioned using the quick or
series commissioning, in the following step parameters should be adapted and set
according to the technological requirements. As an example, the following points
should be considered:
Functional requirements of the drive inverter (e.g. closed-loop process control
with PID controller)
Limit values
Dynamic requirements
Starting torques
Load surge requirement
Overload
Diagnostics
If the application includes a function, which is not covered by the quick or series
commissioning, then the following sections of the function description or the
parameter list should be considered.
Adapting the drive inverter to the application
The parameters designated with * offer more setting possibilities than are listed
here. Refer to the parameter list for additional setting possibilities.
START
Factory setting: Bold
User access level *
P0003 = 3
Supply voltage (enters the voltage in V)
P0210 = ?
This parameter enters the real line supply voltage to which the drive
inverter is connected. This entry defines the levels for DC link
overvoltage/undervoltage. Further, the braking thresholds are set.
Inverter overload reaction
P0290 = 2
This defines the response of the drive inverter to an internal overtemp.
Motor cooling (enters the motor cooling system)
P0335 = 0
86
1 Standard (basic applications)
2 Extended (standard applications)
3 Expert (for complex applications)
0 Reduce output frequency
1 Trip (F0004)
2 Reduce pulse frequency and output frequency
3 Reduce pulse frequency then trip (F0004)
0 Self-cooled using the shaft mounted fan attach. to the motor
1 Force-cooled using the separately powered cooling fan
2 Self-cooled and internal fan
3 Force-cooled and internal fan
MICROMASTER 440 Operating Instructions
6SE6400-5AW00-0BP0
Issue 10/03
Setting