Smart Card Reader - HP ProBook 640 G1 Maintenance And Service Manual

Smart card reader

Description
Smart card reader for 15.6–in models with TouchPad (includes cable)
Smart card reader for 14-in models with 2-button TouchPad (includes cable)
Smart card reader for 14-in models with 4-button TouchPad (includes cable)
Before removing the smart card reader, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d. Keyboard (see
e. Base enclosure (see
Remove the smart card reader:
1. Release the ZIF connector (1) to which the smart card reader cable is attached, and then disconnect the
smart card reader cable from the system board.
2. Remove the two Torx screws (2) that secure the smart card reader to the base enclosure.
3. Remove the smart card reader (3).
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 64), and then remove the following components:
Service cover on page
Hard drive on page 66)
Optical drive on page 77)
Keyboard on page 80)
Base enclosure on page
65)
91)
Spare part number
748958-001
738398-001
744005-001