Supported Raid Cache Cards - Lenovo System x3750 M4 Installation And Service Manual

Table 16. Supported adapters, slot in which to install the adapters, and information about the adapters. (continued)
Name of adapter
Broadcom NetXtreme II
ML2 Dual Port 10GbaseT
Adapter for System x

Supported RAID cache cards

This section contains descriptive information for the RAID cache cards supported by this server.
The following table lists the supported RAID cache cards.
Table 17. Supported RAID cache cards and where you can install the cache cards.
RAID cache card
ServeRAID M5100 Series 512
MB Flash/RAID 5 Upgrade for
System x (RAID cache card)
ServeRAID M5100 Series 1
GB Flash/RAID 5 Upgrade for
System x (RAID cache card)
74
Lenovo System x3750 M4 Installation and Service Guide
Suggested slot
installation
sequence Notes
– DMTV Network Controller Sideband interface (NC-SI)
Install in the ML • Port 1 on the adapter is the default port for IMM Shared mode
adapter slot on the
when enabled through UEFI.
system board.
• This adapter provides the following features:
– PCIe Gen2 x8 dual-port 10 Gb Base-T controller in 50 mm
– TCP/IP Offload (TOE), Wake on LAN (WOL), UCM and CIM
– Supports standard pNIC or vNIC2 modes
– Unified networking delivering LAN and iSCSI over 10 Gb
– Two independent 10 Gbp Base-T interfaces with SR-IOV
– PCI Express v2.1 with support for x8 link width 10 Gb
– DMTV Network Controller Sideband interface (NC-SI)
Where to install the
card
You can connect this
cache card to the
optional ServeRAID
M5120 SAS/SATA
Controller.
You can connect this
cache card to the
optional ServeRAID
M5120 SAS/SATA
Controller.
capable for IMM2 Shared port access
wide ML2 form factor
capable
Base-T
capability
Base-T and 1000Base-T link modes
capable for IMM2 shared port access
Notes
• This cache card comes with a flash power module
(Supercap pack) that you can attach to this card. It
powers the integrated RAID subsystem long enough to
store the cache contents to flash in the event of a power
loss. The flash power module must be installed remotely
in the server (see "Installing a RAID adapter flash power
module" on page 89) for information about where to install
the flash power module in the server).
• Provides RAID levels 5 and 50 upgrade support.
• Enables the ServeRAID controller to run MegaRAID
firmware.
• Has 72-bit memory.
• This cache card comes with a flash power module
(Supercap pack) that you can attach to this card. It
powers the integrated RAID subsystem long enough to
store the cache contents to flash in the event of a power
loss. The flash power module must be installed remotely
in the server, (see "Installing a RAID adapter flash power
module" on page 89) for information about where to install
the flash power module in the server).