Section 4: Operations; Operation Safety - Grizzly G4030 Owner's Manual

SECTION 4: OPERATIONS

Operation Safety

Damage to your eyes, lungs, and ears could
result from using this machine without
proper protective gear. Always wear safety
glasses, a respirator, and hearing protection
when operating this machine.
Loose hair and cloth-
ing could get caught in
machinery and cause seri-
ous personal injury. Keep
loose clothing and long
hair away from moving
machinery.
NOTICE
If you have never used this type of machine
or equipment before, WE STRONGLY REC-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly Industrial will
not be held liable for accidents caused by
lack of training.
-18-
Vise
The vise can hold material up to ten inches wide
and be set to cut angles up to 45 degrees.
To adjust the angle on the vise:
1. Loosen the lock nut with a 12mm hex wrench
or socket as shown in Figure 13.
2. Use the scale as a guide to set your angle or
use a machinist square to square the blade
to the vise as shown in Figure 14.
3. Tighten the lock nut.
Figure 13. Setting vise angle.
Figure 14. Squaring vise to blade.
1
G4030 6 ⁄ " x 10" Metal-Cutting Bandsaw
2