Grizzly G4030 Owner's Manual page 17

Brackets
The shipping bracket keeps the saw from dam-
age during shipment and must be removed. The
switch control bracket is adjusted to shut the ON/
OFF switch when the saw returns to the horizon-
tal position.
To remove or adjust brackets:
1. Use a 10mm wrench to remove the shipping
bracket shown in Figure 6.
Figure 6. Removing shipping bracket.
2. Loosen the hex nut holding the switch con-
trol bracket with a 10mm wrench (Figure 7).
Rotate the bracket so it is positioned over the
switch in such a way so when the switch con-
trol bracket makes contact with the switch, it
will push the switch down and OFF.
Figure 7. Safety switch bracket.
1
G4030 6 ⁄ " x 10" Metal-Cutting Bandsaw
2
Shipping Bracket
Switch Control
Bracket
Vertical Assembly
The Model G4030 can easily be set up for vertical
cutting operations.
Components and Hardware Needed:
Table ...................................................................1
To assemble the bandsaw for vertical cut-
ting:
1. If a piece of wood is clamped in the vise for
shipping purposes, rotate the handwheel
and remove the wood.
2. Lift the saw to the vertical position. Rotate
the feed ON/OFF valve to the OFF position,
as shown in Figure 8.
Feed Rate
Dial
Feed ON/OFF
Valve
Figure 8. Feed ON/OFF valve and feed rate
dial.
Qty
-15-