Grizzly G4030 Owner's Manual page 19

Test Run
Projectiles thrown from
the machine could cause
serious eye injury. Wear
safety glasses during
assembly and operation.
NOTICE
DO NOT operate saw without checking gear
box oil level! Operating without sufficient
oil will damage the machine.
Starting the machine:
1. Read the entire instruction manual.
2. Check the gear box oil level to ensure it has
oil.
3. Make sure all tools and foreign objects have
been removed from the machine.
4. Put on safety glasses and secure loose
clothing or long hair.
5. Raise the bandsaw and close the feed ON/
OFF valve to keep the saw in place.
6. Start the bandsaw while keeping your finger
near the ON/OFF switch at all times dur-
ing the test run. The bandsaw should run
smoothly with little or no vibration.
— If you suspect any problems, imme-
diately stop the bandsaw, refer to the
Troubleshooting section, and correct
before continuing.
—If you need any help with your bandsaw
call our Tech Support at (570) 546-9663.
1
G4030 6 ⁄ " x 10" Metal-Cutting Bandsaw
2
Recommended
Adjustments
The adjustments listed below have been per-
formed at the factory. However, because of the
many variables involved with shipping, we rec-
ommend that you at least verify the following
adjustments to ensure the adjustments remain
unchanged.
Step-by-step instructions on verifying these adjust-
ments can be found in SECTION 7: SERVICE.
Factory adjustments that should be verified:
1. Blade Tracking (Page 30).
2. Squaring the Blade (Page 31).
3. Blade Guide Bearings (Page 32).
-17-