Grizzly G4030 Owner's Manual page 23

Cutting Fluid
While simple in concept and function, many
issues must be taken into account and to find
and use the correct cutting fluid. Always follow all
product warnings and contact the fluid manufac-
turer for unanswered questions.
Use the selections below to choose the appro-
priate cutting fluids:
• For cutting low alloy, low carbon, and gen-
eral-purpose category metals with a bi-metal
blade —use a water soluble cutting fluid.
• For cutting stainless steels, high carbon, and
high alloy metals, brass, copper and mild
steels—use "Neat Cutting Oil" (commonly
undiluted mineral oils) that have extreme
pressure additives (EP additives).
• For cutting cast iron, cutting fluid is not rec-
ommended.
Remember: Too much flow at the cutting fluid
nozzle will make a mess and can make the work
area unsafe; and not enough fluid at the cut will
heat the blade, causing the blade teeth to load up
and break.
BIOLOGICAL
POISON HAZARD! Use
proper personal protection
equipment
handling
and follow federal, state,
and fluid manufacturer
requirements to properly
dispose of cutting fluid.
1
G4030 6 ⁄ " x 10" Metal-Cutting Bandsaw
2
AND
when
cutting fluid
Blade Guides
The blade guides should be as close to the
workpiece as possible. This will help ensure
straight cuts by keeping the blade from twisting
and drifting off the cut line.
To adjust the blade guides:
1. Loosen the knob shown in Figure 21 and
slide the rear blade guide as close to the
workpiece as possible, then tighten the
knob.
Knob
Figure 21. Blade guides.
Blade Guides
-21-