Lights And Visibility; Lights - Skoda Rapid Owner's Manual

If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down
by several centimetres.
If you attempt to close the window again within 10 seconds of the window be-
ing moved down for the second time, even though the obstacle was not yet
been removed, the closing process is only stopped. During this time, it is not
possible to automatically close the window. The force limiter is still switched
on.
The force limiter is only not operational if you attempt to close the window
again within the next 10 seconds – the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
WARNING
Variant 1 of the power window
windows should be closed carefully – risk of injury!
Operational faults

Read and observe and
Repeatedly opening and closing the window can cause the window mecha-
nism to overheat and become temporarily blocked. You will be able to operate
the window again as soon as the operating mechanism has cooled down.
For Variant 2, the windows may not operate automatically after disconnecting
the battery. After connecting the vehicle battery, the system is activated as
follows.
›
Switch on the ignition.
›
Pull the top edge of the relevant button and close the window.
›
Release the button.
›
Pull up the respective button and hold for 1 second.
» fig. 24 on page 38has no force limiter. The
on page 38 first.

Lights and visibility

Lights


Introduction
This chapter contains information on the following subjects:
Operating the light function
Daytime running lights(DAY LIGHT)
Turn signal and main beam
Fog lights/rear fog light
Parking light
Hazard warning light system
Notice
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
Operating the light function
To switch the light function on / off, switch
one of the following positions.
Switching off lights (except daytime running lights)

Switching on the parking lights or parking lights on both sides

Turn on the low beam

To adjust the headlight range control, turn dial
hicle load » .
Front seats occupied, boot empty

All seats occupied, boot empty

Fig. 25
Light switch and control dial for
the headlight beam range regu-
lation
» fig. 25 should be turned to
A
» page 41
» fig. 25in line with the ve-
B
Lights and visibility
39
40
40
41
41
41

39