Table of Contents
Advertisement
5-4 What to Do If...
Is the tool firmly secured in place?
Retighten the collet to secure in place firmly.
P. 59, "Installing a Tool," p. 73, "Installing the Engraving
Cutter and Setting the Origin Point"
Is the tool tip worn?
If the tip of the tool is worn, replace with a new
tool.
What to Do If a Flashing Error Is Displayed
If the lamps are flashing as shown below,
then an error has occurred on the machine.
To correct the error, follow the steps de-
scribed below.
The MODELING and SCANNING lamps
An error occurred during initialization of
the machine.
Switch the power off, then back on. If the error is
not cleared when you switch the power on again,
the machine may be malfunctioning. Contact your
authorized Roland DG Corp. dealer.
The MODELING and VIEW lamps
A front cover was opened during cutting or
spindle rotation.
Operation cannot be continued. Close the front cover
and press the sub power button.
The MODELING lamp
The spindle motor error occurred.
Operation cannot be continued. Press the sub power
button to clear the error. Make the program's cutting
parameters more relaxed to lessen the load applied
to the spindle.
80
Chapter 5 Appendix
Chapter 5 Appendix
Installation is Impossible
If installation quits partway through, or if the wizard
does not appear when you make the connection with
a USB cable, take action as follows.
Windows Vista
1. If the [Found New Hardware] appears, click [Cancel]
to close it. Disconnect any USB cables for printers or
other such equipment other than this machine.
2. Click the [Start] menu, then right-click [Computer].
Click [Properties].
3. Click [Device Manager]. The [User Account Control]
appears, click [Continue]. The [Device Manager] ap-
pears.
4. At the [View] menu, click [Show hidden devices].
5. In the list, find [Printers] or [Other device], then
double-click it. When the model name you are using
or [Unknown device] appears below the item you
selected, click it to choose it.
6. Go to the [Action] menu, and click [Uninstall].
7. In "Confirm Device Uninstall" window, select [De-
lete the driver software for this device.], then click
[OK]. Close the [Device Manager].
8. Detach the USB cable connected to the printer, and
the restart Windows.
9. Uninstall the driver. Carry out the steps from step
3 in page 81 "Uninstall the Driver Windows Vista" to
uninstall the driver.
10. Install the driver again according to the procedure
in page 38 "Installing the Windows-based Driver. "
Windows XP
1. If the [Found New Hardware Wizard] appears, click
[Finish] to close it. Disconnect any USB cables for
printers or other such equipment other than this
machine.
2. Click the [Start] menu, then right-click [My Com-
puter]. Click [Properties].
3. Click the [Hardware] tab, then click [Device Man-
ager]. The [Device Manager] appears.
4. At the [View] menu, click [Show hidden devices].
5. In the list, find [Printers] or [Other device], then
double-click it. When the model name you are using
or [Unknown device] appears below the item you
selected, click it to choose it.
6. Go to the [Action] menu, and click [Uninstall].
Advertisement
Table of Contents
