Table of Contents
Advertisement
Available languages
Available languages
DHWE 50S, DHWE 80S, DHWE 100S
10 Indication of errors
In case of error, control lights start to flash on the dis-
play 1.
Error
Error description
E1
Temperature sensor error
E5
Overheating (temperature > 90 °C)
E44
Dry start
11 Cleaning
To clean the appliance is switched off. The surfaces of
the hot water tank can be cleaned by wiping it with a
damp soft cloth. Do not use scouring powder or furni-
ture polish, as these may damage the surface.
12 Conformity
The units of these series are according to the
following relevant EU directives and applied
standards:
EU directives:
LVD 2006/95/EC
EMC 2004/108/EC
Standards:
EN 60335-1, EN 60335-2-21
EN 55014-1, EN 55014-1, EN 62233
EN 61000-3-2, EN 61000-3-3
EN-16
Signalization
Repeated 2x quick pulse of the control
light on the display A1
Repeated 3x quick pulse of the control
light on the display A1
Repeated 4x quick pulse of the control
light on the display A1
13 Warranty
The warranty conditions in the country of purchase
apply to this appliance. Information can be obtained at
any time from the retailer from who the appliance was
purchased.
14 Recycling
hold waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice
in your country.
DHWE_50_100_gb · 06/15/A
Solution
Call service (heater out of order).
The error is automatically deleted
when the temperature drops below
the set value. Should the error
repeat, please call the service com-
pany.
Fill the heater with water. The error
is deleted by switching off the heater
or by holding button T1 for 3
seconds.
For electrical products sold within the Euro-
pean Community.
At the end of the electrical products useful
life it should not be disposed of with house-
www.dimplex.de/en
Advertisement
Table of Contents
