4.3.4
IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press <Enter>
if you wish to configure the item.
IDE Configuration
OnBoard PCI IDE Controller
Serial-ATA Devices
nVidia RAID Setup
Primary IDE Master
Primary IDE Slave
Serial-ATA 0 Primary Channel
Serial-ATA 0 Secondary Channel
Serial-ATA 1 Primary Channel
Serial-ATA 1 Secondary Channel
Serial-ATA 2 Primary Channel
Serial-ATA 2 Secondary Channel
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
OnBoard PCI IDE Controller [Enabled]
Enables or disables primary IDE controllers.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1/2]
Enables or disables the SATA0/1/2 IDE interfaces.
Configuration options: [Disabled] [Device 0] [Device 0/1] [Device 0/1/2]
nVidia RAID Setup
This menu enables you to enable or disable RAID mode for each ATA
channhels while entering setup.
nVidia RAID Function
nVidia RAID Function [Disabled]
Enables or disables the nVidia RAID function.
Configuration options: [Disabled] [Enabled]
ASUS KFN5-Q Series
[Both]
[Device 0/1/2]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
[Disabled]
[35]
[Host & Device)
[Disabled]
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
Options
Enabled
Disabled
4-11