Table of Contents
Advertisement
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
3.
SAS LSI1068 ports LED connector (18-1 pin SASLED1)
( For KFN5-Q/SAS model only )
This connector is for SAS link state's LED. The active LOW Fault LED
signals are nominally configured to indicate a SAS link fault for each
respective phy. The active LOW Activity LED signals are nominally
configured to indicate SAS link activity.
KFN5-Q Series SASLED Connector
ASUS KFN5-Q Series
Drive jumper
setting
Cable-Select or
Master
Cable-Select
Master
Slave
Mode Cable of
device(s)
-
Master
Slave
Master
Slave
SASLED1
Cable connector
Black
Black
Gray
Black or gray
2-33
Advertisement
Table of Contents
