Table of Contents
Advertisement
Available languages
Available languages
Alarm module
● Connected loads
Test voltage
Switching thresholds for supply to EN 60947-5-6: U
1)
Position feedback module
Position feedback module
1 DC output for position feedback
Rated signal range
Dynamic range
Fault current
1)
External load R
[kΩ]
B
Transmission error
Temperature influence
Resolution
Ripple content
For connecting to circuits with the
following peak values
Galvanic isolation
Test voltage
In case of device fault or failure of setpoint power I
1)
Appendix
Certificate
The certificates can be found on the enclosed CD and on the Internet under:
SITRANS VP300 certificates on the Internet (www.siemens.com/certificates/vp300)
Technical support
Technical Support
You can contact Technical Support for all IA and DT products:
● Via the Internet using the Support Request:
Support request (http://www.siemens.com/automation/support-request)
● E-mail (mailto:support.automation@siemens.com)
● Phone: +49 (0) 911 895 7 222
● Fax: +49 (0) 911 895 7 223
Further information about our technical support is available in the Internet at
Technical Support (http://www.siemens.com/automation/csi/service)
SITRANS VP300 (6DR63..)
A5E03359515-01, 03/2011
Without explosion protection
6DR6003-8A
-
= 8.2 V, R
H
Without explosion protection
6DR6003-8J
4 ... 20 mA, protected against polarity reversal
See Chapter Electrical specifications (Page 28)
Electrically isolated from the basic device
w
With explosion protection Ex "ia", "ic",
"nA"
6DR6003-6A
U
= ≤ 5.9 V
o
I
= ≤ 0,2 mA
o
P
= ≤ 1,2 mW
o
C
= ≤ 1 μF
o
L
= ≤ 1 mH
o
DC 840 V, 1 s
= 1 kΩ)
i
With explosion protection Ex "ia", "ic",
"nA"
6D6003-6J
2-wire connection
3,6 ... 20.5 mA
2.4 to 3.6 mA
≤ (U
[V] - 12 V)/i [mA]
H
< 0,3 %
≤ 0.1%/10 K
< 0,05 %
< 0,1 %
DC 840 V, 1 s
33
Advertisement
Table of Contents
