Subaru impreza 2017 Owner's Manual page 226

3-84
Instruments and controls/Mirrors
7. Return to the vehicle and firmly press,
hold for two seconds and release the
HomeLink button up to three times. At this
point programming is complete and your
device should operate when the
HomeLink button is pressed and released.
1) Status Indicators
8. If status indicator arrows appear next
to the indicator light, please refer to
Garage Door Two-Way Communication
3-85.
In the event that there are still program-
ming difficulties or questions, additional
HomeLink information and programming
videos can be found at
www.HomeLink.com and
www.youtube.com/HomeLinkGentex. For
Genie and Sommer garage door openers
please go directly to the HomeLink web-
site.
Gate Operator / Canadian Pro-
gramming
Canadian radio-frequency laws require
transmitter remote signals to time-out
(or quit) after several seconds of transmis-
sion, which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian
law, some U.S. gate operators are de-
signed to time-out in the same manner.
The indicator LED on the hand-held
remote will go off when the device times
out, indicating that it has finished transmit-
ting.
If you live in Canada or you are having
difficulties programming a gate operator or
garage door opener by using the program-
ming procedures, replace Programming a
New HomeLink Button step 3 with the
following:
While the HomeLink indicator light is
flashing orange, press and release ( cy-
cle ) your device s hand-held remote
every two seconds until the HomeLink
indicator light changes from orange to
green. You may now release the hand-
held remote button.