Bosch Ultima 862 Quick Reference Manual page 15

Solution Ultima 862
Polarity (Modes)
Option
Disabled
0
Normally Open, Going Low
1
Normally Open, Pulsing Low
2
Normally Open, One Shot Low
3
Normally Open, One Shot Low (Reset)
4
Normally Open, One Shot Low (Re-trigger)
5
Normally Open, One Shot Low (Alarm)
6
Normally Open, Latching Low
7
Time Base
Choose one of the options in the table below for the time base.
Time Base Multiplier
Enter a value between 01 – 99.
One Shot Mode
When you program the output polarity as a one shot, the time base is multiplied by the time base multiplier (eg.
If the time base = 2 and the multiplier = 05, the output will operate for 5 seconds)
Pulsing Mode
When you program the output polarity as pulsing, the time base becomes the 'ON' time and the multiplier
becomes the 'OFF' time. The 'OFF' time is the time base x the multiplier
one (1) second 'ON' and five (5) seconds 'OFF', you would program time base as one (1) and the multiplier as
five (5)).
Quick Reference Guide
Description
Option
200 ms
1
1 Second
2
1 Minute
3
1 Hour
4
Option
Normally Low, Going Open
8
Normally Low, Pulsing Open
9
Normally Low, One Shot Open
10
Normally Low, One Shot Open (Reset)
11
Normally Low, One Shot Open (Re-trigger)
12
Normally Low, One Shot Open (Alarm)
13
Normally Low, Latching Open
14
Description
(eg. If you want the output to pulse
SOL ULTIMA 862 QUICK REF GUIDE
Description
15