Bosch Ultima 862 Quick Reference Manual page 19

Solution Ultima 862
Solution Ultima RF Receiver Interface Connections
Wiring and Power Up
- Remove power from the control panel.
- Connect the RF Receiver to the control panel as shown
above using 0.8mm (22-gauge) or larger wire. Wire length
should not exceed 300 meters (1000 feet).
- Apply power to the control panel. The red LED at the centre
of the module will turn on.
RF Keyfob Operations For Solution Ultima Series Control Panels
Figure 2: RF3332 - 2 Button RF Keyfob
Quick Reference Guide
Figure 1: RF Receiver (RF3212) Wiring Diagram
Electronics Design and Manufacturing Pty LimitedSOL ULTIMA 862 QUICK REF GUIDE.D
Operation
The following describes the status of the module based on the LED
condition.
LED On – Module is functioning normally.
LED Off – Power failure has occurred or module is not wired
correctly.
LED Turns Off Momentarily – Module acknowledged receiving an
RF signal from a remote RF device.
Figure 3: RF3332 - 2 Button RF Keyfob
19