Table of Contents
Advertisement
Note:
This feature is available to Windows computer users. If you are a Mac
user, do not enable this option because you will be unable to access
your device.
To enable IP pass through mode:
1.
From a computer that is connected to your network, launch a web browser.
2.
Enter http://m.home or http://192.168.1.1.
A login page displays.
3.
Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4.
Select Settings > Setup > Router Setup.
The ROUTER SETUP page displays.
5.
Select the IP PASSTHROUGH ON button.
The default selection is AUTO.
Specify the IP Addresses That the Mobile Router Assigns
By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The
router assigns IP, DNS server, and default gateway addresses to all computers connected to
the LAN. The assigned default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router's LAN IP
address. Using the default addressing scheme, define a range between 192.168.1.2 and
192.168.1.254, although you can save part of the range for devices with fixed addresses.
To specify the pool of IP addresses that the mobile router assigns:
1.
From a computer that is connected to your network, launch a web browser.
2.
Enter http://m.home or http://192.168.1.1.
A login page displays.
3.
Enter the administrator login password.
The password is case-sensitive.
The dashboard displays.
4.
Select Settings > Setup > Router Setup.
The ROUTER SETUP page displays.
5.
Enter the starting IP address and the ending IP address.
Nighthawk M1 4GX Gigabit LTE Mobile Router
Specify Mobile Router Network Settings
52
Advertisement
Table of Contents
