Fan - HP ProDesk 405 G1 Microtower Maintenance And Service Manual

Fan

Description
Fan
Fan, BFR/PVC free
1. Prepare the computer for disassembly
2. Remove the access panel
3. From the outside, rear side of the chassis, remove the two Torx T15 screws that secure the fan to
the chassis.
4. From the inside of the chassis, disconnect the fan control cable (1) from the system board
connector labeled CHFAN2.
5. Lift the fan out of the chassis (2).
NOTE:
To install the fan, reverse the removal procedure. Be sure to orient the air flow out of the computer.
58 Chapter 5 Removal and replacement procedures: Microtower
(Access panel on page
System board appearance may vary.
(Preparation for disassembly on page
27).
Spare part number
745052-001
748825-001
26).