Tv Channel Setting - Audiovox PVS21090 Instruction Manual

TV SETUP

TV CHANNEL SETTING

1. Press the TV MENU button.
2. Use the or button to select TV CHANNEL
SETTING.
3. Use the or
(Antenna / Auto Scan / Auto Scan Add CH
/ Channel Skip / Channel No. / Channel
Label).
4. Use the or
The screen will change to your selected mode
immediately. Press the TV MENU button to
return to the previous menu.
5. Repeat steps 2 to 4 to adjust other options.
6. To exit the TV SETUP MENU and return to
the normal screen, press the EXIT button on
the remote control.
NOTE
Channel No. : 2-69 Channel for Air, 1-135
Channel for CATV.
Antenna :
Auto Scan :
Auto Scan Add CH :The stored channels can not be cleared and
Channel Skip:
Channel Label:
1. Select the Channel Label item and press the
into the channel label edit screen.
2. Use the or
3. Use the or
4. After editting, press the DISPLAY button and the Channel &
Channel Label will be shown on the screen.
E
15
button to select the options
button to make adjustment.
Select "CATV" to receive cable signal. Select
"AIR" to receive air singal.
Automatically search all channels for those
with adequate signal strength.
the Auto Scan Channels will be added.
If you has selected CATV in TV CHANNEL
SETTING, then you can select Cable System
(AUTO / STD / HRC / IRC) in the sub menu
as the picture shown.
You may switch ON/OFF the skip function of
each stored channel by selecting the channel
with / button (and using
select page if the amount of stored channels in
more than 1 page), and followed with pressing
the ENTER button.
You may edit one label for each channel.
button to enter the number or letter.
button to move and edit for the next character.
Antenna
Auto Scan
Auto Scan Add CH
Channel Skip
Channel No.
Channel Label
UP/DOWN
/ button to
or button to go
Air
ADJUST "MENU":EXIT
Cable System Auto
Start to Scan
ADJUST "MENU":EXIT
UP/DOWN
No. Program Name Skip
2.0 Off
3.0 Off
"MENU":EXIT
"ENTER":SELECT
1 2 3 #
EDIT SELECT "MENU":EXIT