Using The Tv; Searching For Tv Channels Automatically; Manual Searching For Tv Channels; Watching Television - Audiovox PVS21090 Instruction Manual

USING THE TV

Connect an antenna or CATV cable or Satellite system to the TV antenna terminal
before searching TV channels.

Searching for TV channels automatically

(Only appears to the first time Power ON)
1. Connect the TV antenna.
2. Connect the AC adapter and AC cord.
3. Press the / ON button to turn on the unit.
4. Press the ENTER button.
5. Press the or button to select "Air" or "CATV", then press the
ENTER button to start auto scan.
6. The unit will immediately search all channels for those with adequate
signal strength and store those channels with signals in memory. The
unit will take a short minutes to finish auto scan and aftter this is
completed, the unit will switch to the first channel found.

Manual searching for TV channels

1. Press the TV MENU button, then press the
CHANNEL SETTING.
2. Press the button to select ANTENNA. Use the
select AIR or CATV.
3. Use the button to select Auto Scan.
4. Press the ENTER button to enter sub menu of Auto Scan.
5. Use the button to select "Start to Scan" in the sub menu.
6. Press the ENTER button to start the search for TV channels.
7. The screen will show the first received channel when auto search is completed.

Watching television

Viewing a television station after the auto/manual search for channels.
1. Press the FUNCTION button to TV mode.
2. Press the CH+ or
select the channel you want to watch.
• For channels 1 to 9, enter one-digit channel number.
• For channels 10 to 99, enter two-digit channel number.
• For channels 100 or over, enter three-digit channel number.
NOTE
• When a channel is selected, the channel number is displayed on the top right corner of the screen.
This number will disappear after a few seconds.
ATSC TV mode:
Press the DISPLAY button, the upper
window will pop up, then press the
DISPLAY button again, the lower window
will pop up. Press the DISPLAY button
once to exit.
NTSC TV mode:
Press the DISPLAY button, the upper
window will pop up, then press the
DISPLAY button once to exit.
CH- button to select a channel, or press the number button on the remote to
Position no.
ATSC data
information
(only ATSC)
button to TV
or button to
ATSC data information
(only ATSC)
Time information
information
2.3 Xxxxxxx Xxxx
AUDIO 1/1(L+R)
2007/01/31 07:38 07:00-08:00 TV LEVEL: Good
Xxxx xx xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
PROCEED WITH AUTO SCAN?
NO YES
: SELECT
"ENTER" : CONFIRM
PLEASE SELECT ANTENNA TYPE.
AIR CATV
: SELECT
"ENTER" : CONFIRM
RF CH 13
Found 0
Press "MENU" To Exit Auto Scan
Signal
information
strength
Audio
(only ATSC)
FTA
Rating
E
12