Table of Contents
Advertisement
A+ SERVER 2022TC-BIBQRF/BTRF USER'S MANUAL
6-9
Drive Bay Installation/Removal
Accessing the Drive Bays
SATA Drives: You do not need to access the inside of the chassis or remove power
to replace SATA drives. Use standard 1" high, SATA drives in the system.
Note: Refer to Supermicro's web site for setup guidelines: http://www.supermicro.
com/support/manuals/.
The SC827 chassis contains four individual serverboards in separate node drawers.
Each serverboard node controls a set of three hard drives (see Figure 6-15). Note
that if a serverboard node drawer is pulled out of the chassis, the hard drives
associated with that node will power down as well.
Serverboard Drawer Locations in the Chassis
Serverboard B
Controls HDDs B1, B2 and B3
Serverboard A
Controls HDDs A1, A2 and A3
Figure 6-15. Hard Drives and the Corresponding Serverboards
1
A
1
B
1
C
1
D
6-14
Serverboard D
Controls HDDs D1, D2 and D3
Serverboard C
Controls HDDs C1, C2 and C3
Advertisement
Table of Contents
