Table of Contents
Advertisement
Figure 6-14. Installing an Expansion Card
Bracket
Bracket Screws
Note: The serverboard node drawer is an example only, actual layout differs slightly
4. Connect the expansion card to the riser card.
5. Secure the riser card to the serverboard tray using the riser card screw.
6. Slide the expansion card bracket into the rear expansion card slot and secure
with the expansion card bracket screws.
7. Close the expansion card slot clip.
Note: Under normal circumstances, the riser card and expansion card bracket are
not separated.
Note: The serverboard node drawer accepts expansion cards up to a maximum of
5.9" (149,86 mm) in length.
Expansion
PCI Slot
Card
Shield
6-13
Chapter 6: Advanced Chassis Setup
Riser Card
Screw
Riser Card
Advertisement
Table of Contents
