Superio Device Configuration; Remote Access Configuration - Supero 2022TC-BIBQRF User Manual

Load Onboard LAN 1 Option ROM
This option allows you to enable or disable the onboard LAN 1 option ROM.
Load Onboard LAN 2 Option ROM
This option allows you to enable or disable the onboard LAN 2 option ROM.
Boots Graphic Adapter Priority
This option specifies the priority for booting the graphic adapter for Onboard
VGA or Offboard VGA.
 SuperIO Device Configuration
Serial 1 Address
This option specifies the base I/O port address and Interrupt Request address
of serial port 1. Select "Disabled" to prevent the serial port from accessing any
system resources. When this option is set to Disabled, the serial port physically
becomes unavailable. Select "3F8/IRQ4" to allow the serial port to use 3F8 as its
I/O port address and IRQ 4 for the interrupt address. Options include Disabled,
3F8/IRQ4, 3E8/IRQ4 and 2E8/IRQ3
Serial 2 Address
This option specifies the base I/O port address and Interrupt Request address
of serial port 2. Select "Disabled" to prevent the serial port from accessing any
system resources. When this option is set to "Disabled", the serial port physically
becomes unavailable. Select "2F8/IRQ3" to allow the serial port to use 2F8 as its
I/O port address and IRQ 3 for the interrupt address. Options include Disabled,
2F8/IRQ3, 3E8/IRQ4 and 2F8/IRQ3.
Serial Port 2 Attribute
This option allows you to set COM2 as a normal serial port or as virtual COM
for SOL. Options are SOL or COM.
 Remote Access Configuration
Remote Access
Use this option to Enable or Disable Remote Access in your system. If enabled,
the settings below will appear.
7-9
Chapter 7: BIOS