Table of Contents
Advertisement
BIOS EHCI Hand Off
This is a workaround for OS's without EHCI hand-off support. The EHCI
ownership change should be claimed by the EHCI driver. Options are Enabled
or Disabled.
Legacy USB 1.1 HC Support
This option Enables or Disables support for legacy USB 1.1 HC.
USB Mass Storage Device Configuration
USB Mass Storage Reset Delay
This option set the number of seconds that POST waits for the USB mass
storage device after the Start Unit command. Options include 10 Sec,
20 Sec, 30 Sec and 40 Sec.
Device # Emulation Type
This option sets the device emulation type. If Auto, USB devices less
than 530MB will be emulated as Floppy and remaining as a hard drive.
The Forced FDD option can be used to force a HDD formatted drive to
boot as an FDD drive.
Active State Power Management
This option enables/disables the PCI Express L0s and L1 link power states.
Options include Enabled or Disabled.
IDE Configuration
Onboard PCI IDE Controller
This setting allows you to enable the Primary or Secondary PCI IDE controller.
Options include Disabled, Primary, Secondary or Both.
Primary/Secondary/Third/Fourth IDE Master/Slave
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk
drive. The options are Disabled and Auto.
7-11
Chapter 7: BIOS
Advertisement
Table of Contents
