barbas Cuatro-2 60 Installation Instructions Manual page 35

CUATRO-2 60 CUATRO-2 70 CUATRO-2 80
We recommend that you maintain a substantial layer of ash (2 - 3 cm). This not
only forms a protective layer for the base of the appliance but also signifi cantly
reduces consumption of fuel and allows new wood to catch light easier.
When loading the fi re with fuel, two blocks measuring 30 cm long and 30 cm
perimeter is suffi cient. Do not add more fuel until the previous fuel has burned
down to the charcoal stage.
The fl ames are then almost no longer visible. Do not leave the door open longer
than necessary.
Weather conditions
In order to reduce pollution and any other inconvenience, we advise not fi ring up
the fi re when there is no wind, or in foggy/misty conditions.
Smoke development
Your fi re has been designed to be used with the load/observation door closed.
Should you use it with the door open, under certain circumstances (presence of
mechanical ventilation, draught, differences in barometric pressure) smoke may
enter the room in which the fi re is situated.
Use of the fi re
Your fi re is suitable for periodic use.
The fi re may only be positioned in a place where the location, construction and
activity in the room can accommodate it without danger.
Ventilation
When using the fi re, ensure a good supply of fresh air, particularly if the
combustion air is drawn from the room itself. Turn on the fl ue gas fan if the fl ue
is fi tted with one.
Spare parts
Any replacement parts must be new, original parts. Use of non-original/
reconditioned parts will invalidate your warranty.
Modifi cation
Do not make modifi cations to your fi re. Any alteration to your fi re, of whatever
nature, will also invalidate your warranty.
35