•
Clad the appliance on the top, sides and rear up to the front edge with an
approx. 10 cm thick ceramic isolation wool fi reblanket. Leave a few
centimetres clearance between the front of the chimney breast and the
appliance.
•
Level off the appliance. Check that the slides do not catch on the base.
•
Make a good seal between the smoke outlet from the appliance to the
chimney. See also 3.3.4.
Ensure that the entire fl ue is gas-tight.
•
Ventilate the chimney, by placing ventilation openings at the top and bottom
of the chimney breast.
Figure 1: Use of convection set and ventilation of fi replace
•
Close up the front.
20
CUATRO-2 60
CUATRO-2 70
CUATRO-2 80