Hitachi RX Technical Manual page 64

(4) Bar code use and bar code type
● Two or more bar code types cannot coexist.
● When bar code set up is completed for a print item, its inter-character space can not be changed.
(The inter-character space need not be transmitted in this case.)
● When the bar code type is ITF or code128(code set C), you have to observe the following input rules.
If you violate the rules, the contents of an illegal print item will be deleted.
ITF or code128(code set C) input rules
No.
Characters must be paired to make an
1
entry.
● Some characters cannot be entered depending on the bar code type.
If any unacceptable character is included in a print item for which bar code setup is completed, the
contents of the print item are changed to a null character. See "4.7.5 Print a bar code" of the
Instructions Manual.
● FNC1 is a control code used for Code128, 2-byte code of 81A6, indicated as
5.3.5-3 Example of print conditions transmission
(1) Example where print item is not specified
02H 1FH 22H
STX ESC2 "
Header,
classification
[Transmission results]
All print items are set as 1 stage, write position is changed to 0123.
(2) Example where print item is specified
02H 1FH 70H 31H 1FH 23H 31H 34H 30H 30H 1FH 70H 33H 1FH 23H 31H 34H 30H 30H 03H
STX p 1
ESC2
Header, item No.
[Transmission results]
Upper stage character size is changed.
1
2
Input rule
32H 31H 30H 1FH
2 1 0 ESC2
Line count 1
line spacing 0
# 1 4 0
ESC2
Header,
Character size 7x10,
classification
inter-character space 0
3
4
Input example
(Correct) [012345]
(Incorrect) [01234]
25H 36H 30H 31H
% 6 0
Header,
Write position 123
classification
0 p 3
ESC2 ESC2
Header,
item No.
3
1
2
4
on print layout screen.
※
32H 33H 03H
1 2 3 ETX
# 1 4 0
Header,
Character size 7x10,
inter-character space 0
classification
●Transmission Sequences 5-18
0 EXT