Hitachi RX Technical Manual page 134

Open the "Circulation control" screen, and press the
5
Process prior to long-term shutdown key and the Start/Continue key.
Circulation control
Eject ink
(Goes to Standby)
Nozzle backwash
Ink replacement
Process prior to
long-term shutdown
Select option; press [Start/Cont.]
The following guidance appears. Confirm the message and Press
6
Start/Continue key.
Circulation control
Process : Process prior to
long-term shutdown
Operation guide
Always pay attention to the following before operation.
・Depending on the ink types, storage temperature or storage
term the clogging formed by residual ink the circula-
tion system may occur even if this process is performed.
・For the storing method, it is recommended contact your
local distributor.
Follow the operation guidance on the screen and drain the ink from the ink
7
filter and ink circulation system.
● Press Abort to cancel ink draining.
● When Abort is selected, go back to step 5 above and continue.
[Stop ]
Cleaning stop No-cleaning stop
Recovery-line Makeup refill for
cleaning air removal
Ink filter
Ink circulation
replacement
Process after
Makeup refill
long-term shutdown
Proc. status:
[Stop ]
Proc. status:
Recovery block
2015.07.07 12:45
Com=0
HOME
Prev.Dsp. Next Dsp.
Cancel
Start/Continue
Start/Continue
2015.07.07 12:45
Com=0
InkDrainage
Systemclean
InkDrainage
Systemclean
InkDrainage
Systemclean
Abort
Start/Continue
Start/Continue
CAUTION
If ink is accidentally spilt, wipe it up
promptly with wiping paper or
equivalent.
In addition, do not close the
maintenance cover until you are
sure that the wiped area is
completely dried.
●Long-term Shutdown 6-29