Hitachi RX Technical Manual page 111

Remove the cap and sensor-block, then drain the ink remaining in the ink reservoir.
6
● Clean the inside of the reservoir with makeup.
Fill the reservoir with new ink.
7
● Be sure not to exceed the MAX line.
Insert the tip of the print head into a beaker.
8
● Prepares for bending of the ink stream.
Press Start/Continue .
9
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
● When you want to stop the operation, press Abort .
● When abort processing was performed, select "Ink refill" from the Circulation control screen and
execute.
At the end of operation, the screen returns to the Circulation control screen.
10
Display the Operation management screen and set the Ink operating time to "0".
11
6-6 ●Replacing the ink
MAX line
M A X
1L REFILL
Sensor-block
Cap