System Board Configuration - HP ProLiant SL165z G6 Maintenance And Service Manual

System Board Configuration

Processor
HP ProLiant SL165z G6 Server, with two nodes, supports four-processor operation. With two
processors installed, each node supports boot functions through the processor installed in processor
socket 1.
The processor socket supports AMD Opteron Series processors
CAUTION: It is recommended to use processors of same speeds or cache sizes to prevent possible
server malfunction.
Figure 7 Processor locations
Item
1
2
WARNING: To reduce the risk of personal injury from hot surfaces, allow the heatsink and the
processor to cool before touching them.
To remove the heatsink:
CAUTION: Heatsink screws should be tightened and loosened in opposite sequence. Do not
overtighten the screws as this can damage the system board, connectors, or screws. A maximum
torque of 6-8 in-lb is set for the system.
1. Loosen the first screw about three quarters out, then loosen the second screw completely.
2. Completely loosen the first screw.
3. Lift the heatsink away from the system board.
CAUTION: Place heatsink down in an upright position with the thermal patch facing upward. Do not
let the thermal patch touch the work surface.
Description
Processor 1
Processor 2
Contents 34