HP ProLiant SL165z G6 Maintenance And Service Manual page 73

Table 14
POST error messages
Error code Error message
628 Uncorrectable Memory
ECC Error -
DIMM_J11J12
629 Uncorrectable Memory
ECC Error -
DIMM_J13J14
62A Uncorrectable Memory
ECC Error -
DIMM_J100J101
62B Uncorrectable Memory
ECC Error -
DIMM_J102J103
62C Uncorrectable Memory
ECC Error -
DIMM_J104J105
62D Uncorrectable Memory
ECC Error -
DIMM_J106J107
Checking NVRAM
Update Failed
Operating system not
found
Description/corrective action
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J11 or
DIMM_J12, then replace the broken DIMM
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J13 or
DIMM_J14, then replace the broken DIMM
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J100 or
DIMM_J101, then replace the broken DIMM
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J102 or
DIMM_J103, then replace the broken DIMM
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J104 or
DIMM_J105, then replace the broken DIMM
Set the Memory Channel Mode as "Independent" and the
Uncorrectable Memory ECC error occurred on the DIMM_J106 or
DIMM_J107, then replace the broken DIMM
BIOS could not write to the NVRAM block. This message appears
when the FLASH part is malfunctioning.
Operating system cannot be located on any of the boot

drives.
Verify that the priority boot drive has power and that the IDE

cable is connected properly.
Verify that the desired boot drive has power

Verify that the IDE cable is securely plugged into the

respective system board connectors.
Verify that the boot device is enabled in the Setup Utility.

Verify that the boot device has an operating system installed.

If the problem persists, contact your Foxconn Customer

Support provider.
Contents 73