Installation - National Instruments SCXI-1303 Installation Manual

1 Screw Terminals
2 Bias Resistor Networks

Installation

Note For accurate cold-junction compensation, place the SCXI chassis away from an
extreme temperature differential.
© National Instruments Corporation
Figure 4 shows the SCXI-1303 signal connections.
1
4
3
3 Pullup Resistor Networks
Figure 4. SCXI-1303 Signal Connections
To connect the terminal block to the SCXI module front connector, perform
the following steps:
1. Connect the module front connector to its mating connector on the
terminal block.
2. Tighten the top and bottom thumbscrews on the back of the terminal
block to hold it securely in place.
2
4 Product Name, Assembly
Number, Revision Letter, and
Serial Number.
9
- Pin 1
SCXI-1303 Installation Guide