Lighting For The Fi Rst Time; Lighting And Normal Operation - Superior MONIA Instructions For Installation, Use And Maintenance Manual

6.9 LIGHTING FOR THE FIRST TIME
- Before lighting the stove for the fi rst time, check that the grate is properly
placed and pushed towards the left.
- There will be odours when lighting the fi rst few times due to the evaporation
of paints and oils used during the manufacturing process.
During this stage, air the room well where the stove is installed and avoid
staying there any length of time since the fumes being given off could be
harmful to persons or pets.
The stove body should have settled down and the paints fully evaporated after
having lit the stove a few times.
To this end, follow the instructions given below when using the stove.
- Operate at medium power for the fi rst 5-6 hours after igniting the fuel (the
expansion caused by the heat during this stage will allow the stove body to
settle).
- After the settling-down stage the stove must be set to operate at maximum
power for a period between 6 and 10 hours, depending on the amount of
paint on the stove body that must be evaporated off.

6.10 LIGHTING AND NORMAL OPERATION

Before lighting, remember to check that:
The mains plug is properly inserted into the socket.
The stove door is tightly shut.
The pellet hopper is full or contains sufficient pellets for the stove to operate for the required time.
Keep key 4 pressed down for a few seconds.
A cycle starts with three phases which take the stove into the normal operating mode.
- CONTROL (fi rst 20 seconds)
The lighter (glow plug) activates.
The display LED lights up.
START PHASE I
The extractor fan starts up.
The fuel-loading auger is activated and starts to feed pellets into the grate.
START PHASE II
- If the lighter has triggered the combustion process, the auger increases fuel loading to
allow a period of stabilisation and correct combustion of the pellets in the subsequent
normal operating mode.
- If during the startup phase the sensor on the fl ue gas outlet shows a rise in temperature
(sign that the combustion process is underway), the stove is considered to be lit and goes
into the normal operating mode.
28
STOVE STARTUP
Description of activity
H07023380 / DT2000477-03
The time indicated for operation at maximum power does not necessarily
have to be continuous, but may be divided up into two periods separated
by an interval of at least 3-4 hours with the stove shut down.
At the end of the recommended period the paint will have evaporated and
the stove should be used at the suitable power for normal use.
If necessary the stove may be used for a further period at maximum power
to ensure complete and fi nal disappearance of all paint residue.
When the hopper is being loaded for the fi rst time the loading auger needs
time to fi ll up; during this stage the pellets are not distributed inside the
fi rebox and it is highly probable that the fi rst attempt at ignition fails. If the
alarm is activated, shut down the stove by pressing the ON/OFF key for
a few moments, remove the fuel in the grate and then set the stove for a
new ignition process.
DT2010082-04
DT2011659-00
DT2011660-00
Display
CONTROL (scrolling readout)
START PHASE I (scrolling readout)
START PHASE II (scrolling readout)