Important Information - Superior MONIA Instructions For Installation, Use And Maintenance Manual

Dear Customer,
Thank you for having chosen one of our products, which is the result of years of experience and continuous research aimed at making a superior
product in terms of safety, reliability and performance.
This booklet contains information and advice for safe and effi cient use of your product.

IMPORTANT INFORMATION

• This instruction booklet has been prepared by the manufacturer and is an
integral part of the product. In the event of sale or relocation of the product
make sure this booklet accompanies it, since the information contained in it
is intended for the purchaser and for anyone involved in the installation, use
and maintenance of the product.
• Read the instructions and the technical information contained in this
booklet carefully before proceeding with installation, use or any repairs.
• The observance of the instructions and technical information in this
instruction booklet guarantees the safety of persons and property; it also
ensures more efficient operation and an increased lifespan.
• The factory cannot be held responsible for damage or injury due to failure
to comply with the instructions for installation, use and maintenance given
in this booklet, or due to unauthorised alterations or to the use of other than
original spare parts.
• Appliance installation and use must conform with the manufacturer's
instructions as well as with European and national legislation and local
regulations.
• Installation, electrical connection, checks, maintenance and repairs are
operations which must be carried out exclusively by qualified and authorised
personal with specialised knowledge of the product.
• The wall against which the product is to be placed must not be of wood or
any other flammable material. For correct installation it is also important to
comply with the section entitled "MINIMUM SAFETY DISTANCES".
• Before installing the product read all instruction booklets relevant to the
cladding, the ventilation kit and any other accessory.
• Check that the floor where the product is to be installed is perfectly level.
• When handling the steel parts of the cladding it is advisable to use clean
cotton gloves to avoid leaving fingerprints that are difficult to remove at first
time of cleaning.
• The stove must be assembled by at least two persons.
• Connect the pellet stove to the electricity supply only after it has been
connected by an expert to the flueway.
See the guarantee certifi cate enclosed with the product for the terms, limitations and exclusions.
In line with its policy of constant product improvement and renewal, the manufacturer may make changes without notice.
This document is the property of the factory; no part of it may be disclosed to third parties without the written permission. All rights reserved.
REFERENCE STANDARDS
EN 14785
EN 832
UNI 10683
UNI 10847
UNI 7129
DIN 51731 class HP2
ÖNORM M7135
CEI EN 60335-1
CEI EN 50165
EN 1856-1
EN 1856-2
EN 1443
2
• The plug at the end of the power cable must be easily accessible after
installation.
• Use only recommended wood pellets in the pellet stove (refer to section
entitled "FUEL").
• Never use liquid fuels to light the pellet stove or to relight the embers.
• Ensure that the area where the stove is installed is properly ventilated
while the stove is lit.
• In the event of malfunctioning the fuel supply will be stopped. Restart the
stove only after having eliminated the cause of the malfunction.
• Stop using the product in the event of fault or malfunctioning.
• Do not remove the protective grille from the pellet hopper.
• Any build-up of unused pellets in the burner left over from repeated
failed ignitions must be removed before attempting to light the stove again.
• Stove operation can result in surfaces, handles, flue pipe and glass
becoming extremely hot. When the stove is in operation, only touch these
parts if wearing protective clothing otherwise use suitable tools.
• Because of the build-up of heat on the glass, take care that those who are
unfamiliar with stove operation do not linger near the stove.
• This appliance must not be used by persons (including children) with
reduced physical, sensory or mental capacities, or lack of experience or
knowledge unless they are supervised or instructed on use of the appliance
by the person who is responsible for its safety.
• Creaking may be heard while the stove is in operation or cooling down.
This is not to be considered a defect, but is a consequence of thermal
expansion of the component materials.
• The product you have purchased may different slightly from the one
illustrated in this booklet since the pictures are only given as an indication
and not an exact portrayal.
Residential space heating appliances fired by wood pellets. Requirements and test methods.
Thermal performance of buildings - Calculation of energy use for heating - Residential buildings.
Heat generators fired by wood or other solid biofuels - Installation requirements.
Single flue systems for liquid and solid fuel generators - Maintenance and inspection - Guidelines and procedures
Gas installations for domestic use fired by mains gas supply. Design, installation and maintenance.
Fuels.
Fuels.
Safety of household and similar electrical appliances. - Safety. Part 1: General requirements.
Electrical equipment of non-electric appliances for household and similar purposes – Safety requirements.
Chimneys - Requirements for metal chimneys - Part 1: System chimney products.
Chimneys - Requirements for metal chimneys - Part 2: Metal liners and connecting flue pipes.
Chimneys – General requirements.
H07023380 / DT2000477-03
In the event of difficulties or if you are unable to understand the
instruction booklet, contact your local dealer.
Do not place objects which are not heat-resistant on top of the
stove or within the recommended minimum safety area.
Do not open the door while the stove is in operation or operate
the stove when the glass is broken.
DT2010001-01
DT2010208-07
DT2010209-05