Storing the tire pressure values using the key
Read and observe
on page 148 first.
›
Inflate all of the tyres to the specified inflation pressure.
›
Switch on the ignition.
›
Release the symbol button
» fig. 173
The warning light
in the instrument cluster illuminates.
An acoustic signal sounds and the warning light extinguishes informs that the
storage of the tyre pressure values has taken place.
›
Release the symbol button .
Fig. 173
Button for storing the pressure
values
.
Towing device and trailer
Towing device
Introduction
This chapter contains information on the following subjects:
Removing the ball rod- Step 1
The maximum trailer nose weight when towing a trailer is 75 kg, Vehicles with
four-wheel drive 80 kg and G-TEC vehicles 56 kg. Other data (e.g. shown on
the nameplate of the hitch) on provides information about the test values of
the device.
WARNING
Before each time you make a journey when using the ball rod, check that
■
it is seated correctly and is secured in the mounting recess.
When the knee-joint bar is not used and properly secured in the receiving
■
shaft, it is damaged or incomplete, this must not be used - there is a risk of
an accident.
Do not perform any modifications or changes to the towing device.
■
Keep the mounting recess of the towing device clean at all times. Such
■
dirt prevents the ball rod from being attached securely!
Notice
If the towing device is removed completely, it must be replaced with the origi-
nal reinforcement of the rear bumper which is part of the mount for the towing
eye.
150
150
151
151
152
152
152
153
154
149
Towing device and trailer