Mower Deck Level; Anti-Scalp Rollers; Level Mower Deck (Side-To-Side) - Kubota Z723 Operator's Manual

MOWER DECK LEVEL

BANTI-SCALP ROLLERS
To avoid serious injury:
A Park the machine on a firm and level surface.
A Apply the parking brake.
A Stop the engine and remove the key.
A Wait for all moving parts to stop.
A The flattest cut can be achieved by having the anti-
scalp rollers adjusted off the ground.
Check anti-scalp roller adjustments each time the
mower deck cutting height is changed.
It is recommended that all the anti-scalp rollers be kept
off the ground to minimize scuffing.
1. Check the machine tire pressure.
Inflate tires to the correct pressure. (See "TIRES AND
WHEELS" section.)
2. Start the engine.
3. Raise up the mower deck to the transport position.
(Also the top end of the lift.)
4. Turn the cutting height control dial to adjust height.
5. Lower the mower deck.
6. Adjust the height of the front side anti-scalp roller to
one of 3 positions to approximately 19 mm (3/4 in.)
between rollers and the ground.
Adjust 2 rollers to the same height.
(1) Front side anti-scalp roller
7. Install the roller with attaching hardware.
(H) 19 mm (3/4 in.)
BLEVEL MOWER DECK (Side-to-Side)
To avoid serious injury:
A Park the machine on a firm and level surface.
A Apply the parking brake.
A Disengage PTO (OFF).
A Stop the engine and remove the key while
checking or adjusting the level of the mower
deck.
A Check the machine tire pressure.
Inflate tires to the correct pressure.
(See "TIRES AND WHEELS" section.)
C Checking level (Side-to-Side)
A Mower deck anti-scalp rollers should not contact the
ground.
1. Raise the mower deck to the transport position. (Also
the top end).
2. Turn the cutting height set dial to the 3 in. cutting
height position.
3. Lower the mower deck.
4. Position the right mower blade in the Side-to-Side
position.
5. Measure from outside blade tip to the level surface
with a short ruler or leveling gauge.
Reference
Height of the blade
at the flat surface
A There is a difference of the blade height between on
the flat surface and ground.
6. Check that the left side blade is same height.
The difference between both measurements should
be less than 3 mm (1/8 in.).
7. If the Side-to-Side adjustment is not within the given
tolerance, adjustment is necessary.
Side-to-Side adjustment
ADJUSTMENT 67
76 mm (3 in.)
Less than 3 mm (1/8 in.)