Checking Tire Pressure; Inflation Pressure; Checking Transaxle Fluid Level - Kubota Z723 Operator's Manual

42 PERIODIC SERVICE
BChecking Tire Pressure
To avoid serious injury:
A Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
A Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
A Do not use tires larger than specified.
BInflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it everyday and inflate as necessary.
[Z725]
Tire sizes
13 x 6.5 - 6,
Front
(Non flat) Smooth
24 x 12 - 12,
Rear
(4PR) Turf
[Z724, Z723]
Tire sizes
13 x 5.0 - 6,
Front
(Non flat) Smooth
24 x 9.5 - 12,
Rear
(4PR) Turf
(1) Ground
Recommended Inflation
Max. Pressure
---
69 kPa
(0.7 kgf/cm , 10 psi)
Recommended Inflation
Max. Pressure
---
69 kPa
(0.7 kgf/cm , 10 psi)
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
BChecking Transaxle Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground and shut off the engine and
remove the key.
2. Check to see that the oil level lies between the "MAX"
and "MIN" lines while the machine and oil are at
ambient temperature.
If the level is too low, add the new oil to the prescribed
level into the expansion tank.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
3. Do not overfill past "MAX" line.
Oil expands with heat and may leak from cap during
usage if overfilled.
(1) Transaxle fluid expansion tank
A If oil level is low, do not run engine.
Add the new oil to the prescribed level into the
expansion tank.
A Do not overfill the expansion tank.
(A) MAX line
(B) MIN line