Lexus ES300 Owner's Manual page 51

When the ignition switch is turned off with the wiper lever in the
"AUTO" position, and then the ignition switch is turned on
again, the automatic operation may not work even if raindrops
are on the windshield.
In this case, move the lever to another position and return it to
the "AUTO" position again.
CAUTION
Be careful not to get your fingers caught between the
wipers and windshield.
When the wiper lever is in the "AUTO" position with the
ignition switch on, the wipers
automatically in the following cases:
D If you touch the upper center of the windshield
adjacent to the sensor.
D If you wipe the upper center of the windshield
(adjacent to which the sensor is located) with a towel.
D If the windshield vibrates.
D If you touch the sensor.
NOTICE
Do not apply detergent to or wet the automatic wiper
control sensor when cleaning the inside of the
windshield.
To make the washer squirt, pull the lever toward you and
release it.
Also, the wipers will automatically operate a couple of times
after the washer squirts even with the lever in the "OFF"
position.
The low washer fluid warning light in the instrument cluster
comes on when the fluid level in the tank becomes nearly
empty. For information on adding washer fluid, see "Adding
washer fluid" on page 348.
In cold weather, warm the windshield with the defroster before
using the washer. This will help prevent icing, which could
block your vision.
could operate
Do not operate the wipers if the windshield is dry. It may
scratch the glass.
When waxing your vehicle, make sure that the washer nozzles
do not become blocked. If a nozzle becomes blocked, contact
your Lexus dealer to have the vehicle serviced.
If a nozzle becomes blocked, do not try to clear it with
a pin or other object. The nozzle will be damaged.
SWITCHES
NOTICE
NOTICE
37