Table of Contents
Advertisement
en
... when the appliance is
switched on
The appliance does not start.
-
The mains fuse has tripped.
-
The appliance plug has not been
inserted.
-
The appliance door has not been shut
properly.
... on the appliance
Lower spray arm rotates sluggishly.
-
Spray arm blocked.
The door is difficult to open. *
-
Child-proof lock is activated.
The deactivation instructions
are at the back in the envelope.
* depending on model
Cover on the detergent dispenser cannot
be closed.
-
Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
-
Dispenser was damp when filled.
Refill indicator for salt[]] and/or rinse-
aid
rn
is not lit.
-
Refill indicator/s switched off.
-
Adequate salt/rinse-aid available.
Refill indicator for special salt[]] is lit.
-
No salt.
Refill with special salt.
"Tap _.., display is lit
-
Tap turned off.
20
Water supply interrupted.
Supply hose kinked.
Filter in the water supply blocked.
-
Switch off the appliance and pull
out the mains plug.
-
Turn off the tap.
-
Clean filter in the supply hose.
+
+
-
Reconnect power supply.
-
Turn on the tap.
-
Switch on the appliance.
Water is left in the appliance at the end
of the programme.
-
Waste water hose
is blocked or kinked.
-
Waste water pump blocked,
cover on the waste water pump
is not locked in position
(see Waste water pump).
-
Filters blocked.
-
The programme has not yet ended.
Wait until programme
ends or implement "Reset"
function.
... during the wash cycle
Unusual foam formation.
-
Handwash liquid in the rinse aid
dispenser.
Spilled rinse aid causes excessive
frothing, therefore please remove with
a cloth.
Appliance stops during the wash cycle.
-
Power supply interrupted.
-
Water supply interrupted.
Filling valves making striking noises
-
Caused by the installation of the water
line and has no effect on the function
of the machine. Remedial action is not
possible.
Knocking/rattling noise during rinsing
-
Spray arm is striking utensils.
-
Utensils not arranged correctly.
As soon as the rinse-aid refill
indicator[[] is lit on the fascia, there
is still a rinse-aid reserve of
1-2
rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers .
Combined detergents with rinse-aid
component may be used up to a water
hardness of
21
o
dH (3JC fH,
26°
Clarke,
3.7 mmol/1) only. If the water hardness
is over
21
o
dH, rinse aid must be used.
Open the cover on the rinse-aid
dispenser []ill. To do this, press
the mark ( 1) on the cover
and simultaneously lift
the cover on the control plate (2).
-
Carefully pour in the rinse aid to just
below the edge of the filler opening.
-
Close cover until it clicks shut.
-
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The rinse aid dispensing rate can be
adjusted steplessly. The clear rinse
controller was set to 4 at the factory.
en
Do not change the position of the rinse aid
control unless there are streaks (rotate
towards -) or water stains (rotate towards
+)on the utensils.
9
Advertisement
Table of Contents
