Table of Contents
Advertisement
en
Fresh water connection
-
Connect the fresh-water connection to
the tap according to the installation
instructions with the enclosed parts.
Ensure that the fresh-water connection
is not kinked, crushed or twisted.
-
When replacing the appliance, always
use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa ( 10 bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 1 0 litres/minute
Water temperature:
cold water preferred; hot water max.
temperature 60 °C.
Electrical connection
-
Connect the appliance only to 230 V
and 50 Hz alternating current via
a correctly installed socket with
protective conductor. See rating plate
for required fusing
lli3J.
The socket must be near the appliance
and freely accessible following
installation.
-
The connection may be modified by
technicians only.
-
A power cord extension may be
purchased from customer service only.
-
Use only a residual current operated
circuit-breaker which features
24
the symbol
!Bi!J.
Only this extension
guarantees compliance with
the currently valid regulations.
Removing the appliance
Also observe the sequence of worksteps
here.
-
Disconnect the appliance from the
power supply.
-
Turn off the water supply.
Disconnect the waste water and fresh
water connections.
-
Loosen the fastening screws under the
worktop.
-
If fitted, remove the base panel.
-
Pull out the appliance, carefully pulling
the hose behind.
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
-
Turn on the tap.
Close the door.
-
Select Eco programme
.:!£.
-
Switch on the main switch
[I].
The programme starts running.
-
Wait until approx. 4 minutes have
elapsed.
-
Rotate programme selector
QJ
to the Reset position.
-
After another minute
Switch off the main switch
[I].
-
Turn off the tap.
Transport appliance upright only.
(This prevents residual water from running
into the machine control and damaging
the programme sequence.)
Protection against frost
If the appliance is in a room where there is
a risk of frost (e.g. holiday home}, empty
the appliance completely (see
Transportation).
-
Turn off the tap, disconnect supply
hose and drain water.
Childproof lock (door lock)*
The description of the childproof lock is at
the back in the envelope.
* depending on model
Damage
-
The appliance may be repaired and
opened up by a technician only. To do
this, disconnect the appliance from the
power supply. Pull out the mains plug
or switch off the fuse. Turn off the tap.
Disposal
-
Make redundant appliances unusable
to prevent subsequent accidents.
-
Dispose of the appliance in an
environmentally friendly manner.
en
A
Warning
Children could become locked in the
appliance (risk of suffocation) or find
themselves in other dangerous situations.
Therefore: Pull out the mains plug, sever
and dispose of the power cord. Destroy
the door lock so that the door can no
longer be closed.
Before using your appliance for
the first time
Your appliance was tested before it left the
factory. To remove any remaining test
water, wash the first time without utensils
at the highest temperature. Pour salt, rinse
aid and detergent into the designated
filling orifices.
5
Advertisement
Table of Contents
