Table of Contents
Advertisement
en
Small accessories holder
*
* depending on model
Light-weight plastic accessories, e.g. cups,
lids, etc. can be held securely in the small
accessories holder.
Adjusting
the height of the basket*
*
depending on model
If required, the height of the upper utensils
basket [2[] can be adjusted to provide
more space for tall utensils
either in the upper or lower basket.
Appliance height 81 em
Top basket
Bottom
basket
Setting 1 max.
0
20cm
30cm
Setting 2 max.
0
25cm
25 crTl___j
Appliance height 86 em
Top basket
Bottom
basket
Setting 1 max.
0
20cm
34cm
Setting 2 max.
0
25cm
29cm
Select one of the two following procedures
according to the design of the top basket
for your appliance model:
12
Top basket with side levers
-
Pull out the top basket [2[] out.
-
To lower the basket, press in the left
and then the right
lever on the· outside of the basket. In
doing so, hold the sides of the basket
along the upper edge to prevent it from
suddenly dropping.
To raise the basket, hold
the basket on the sides of the upper
edge and lift it up.
-
Before re-inserting the basket again,
ensure that it is at the same
height on both sides. Otherwise,
the appliance door cannot be closed
and the upper spray arm will not be
connected to the water circuit.
Top basket with upper and lower
roller pairs
-
Pull out the top basket
120
I
out.
-
Remove the upper basket and re-
attach it to the upper (stage 2) or lower
(stage 1) rollers.
Interrupting the programme
-
Switch off the main switch []].
The LEOs go out. The programme
is saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes
and then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
To continue the programme,
switch on the main switch [ ] ] again.
Terminating the programme
(Reset)
-
Only when the main switch is on:
Rotate programme selector [ ] ]
to the Reset position.
-
The programme sequence lasts
approx. 1 min.
-
Switch off the main switch []].
Changing the programme
After you have switched the appliance on,
it is possible to change the programme
within 2 min.
If you want to change the programme
afterwards, the appliance waits until
the initiated programme section
(e. g. washing) ends.
en
A regular inspection and maintenance of
your machine will help to prevent faults.
This saves time and prevents problems.
Overall condition of the machine
-
Check spray arm for grease and
limescale deposits.
If you find such deposits:
-
Fill detergent dispenser with detergent.
Start the appliance without utensils in
the programme with the highest rinsing
temperature.
Clean the appliance with detergents/
appliance cleaners which are particularly
suitable for use with dishwashers.
-
Regularly clean door seal with a damp
cloth.
Never use a steam cleaner to clean your
dishwasher. The manufacturer is not liable
for any consequential damage.
Regularly wipe the front of the appliance
and fascia with a damp cloth; water and a
little washing up liquid are adequate. Do
not use sponges with a rough surface or
abrasive detergents, as these could
scratch the surfaces.
Stainless steel appliances: To prevent
corrosion, avoid using sponge cloths or
wash them out thoroughly several times
before using for the first time.
.&
Warning
Never use other chlorinated household
detergents! Health hazard!
Special salt and rinse aid
-
Check the refill indicators
W
and
[8]. If required, refill salt and/or rinse
aid.
17
Advertisement
Table of Contents
