Siemens SIMATIC S5 CP 523 Manual page 96

CP 523
6.7.1 Print Message Text (Job Numbers 0, 3 and 4)
The CP 523 forwards message text XY to the printer when it receives a "Print out message text XY"
request. You can specify whether the printer is to execute a line feed (LF) or carriage return (CR)
after printing message text XY.
Prerequisites
• You must have configured the message text on the memory submodule. Assign a number to
each message text when configuring it.
• You must have plugged the configured memory submodule into the CP 523.
Specify
• The message text number in binary in byte 0, bits 0 to 3 and in byte 1
• The job number in byte 0, bits 4 to 7
- Job numbers 0 and 3:
- Job number 4:
Additional specificaitons
You can store a further three 16-bit variables in bytes 2 to 7 if you have configured spaceholders
for variables in the message text.
You must enter the data in the format in which you configured it in the message text on the
memory submodule ( 6.4.5).
At printout, the spaceholders are replaced by the current variable values.
Table 6-21. Contents of the Transfer Memory for "Print Message Text"
Byte Bit
0 4 to 7 Job number
0 to 3 Message text number
1 0 to 7
-
2 0 to 7
-
3 0 to 7
-
4 0 to 7
-
5 0 to 7
-
6 0 to 7
-
7 0 to 7
EWA 4NEB 811 6044-02a
Print message text with CR/LF
Print message text without CR/LF
Meaning
Value of the variable
or
number of the message text to
be inserted
Value of the variable
or
number of the message text to
be inserted
Value of the variable
or
number of the message text to
be inserted
Permissible Assignment
0 = Print message text with CR/LF
H
3 = Print message text with CR/LF
H
4 = Print message text without CR/LF
H
001 to FFF (1 to 4095)
H H
0000 to FFFF
H H
Depending on the configured data format
001 to FFF (1 to 4095)
H H
0000 to FFFF
H H
Depending on the configured data format
001 to FFF (1 to 4095)
H H
0000 to FFFF
H H
Depending on the configured data format
001 to FFF (1 to 4095)
H H
Print Mode
6-41