Front Cover - ELNA eXperience 660 Service Manual

REPLACING THE FRONT COVER (UNIT)
TO REMOVE:
Remove the face cover (unit), top cover (unit) and belt cover. (See page 7, 8)
Loosen the setscrews (A), (B) and (C). Then remove the front cover (unit). Disconnect the connector
for printed circuit board-F and flexible flat cable from the printed board-A.
NOTE: Never pull on cord when disconnect the cables from the circuit board.
TO ATTACH:
Follow the procedure in reverse.
Setscrew (C)
SERVICE ACCESS (5)
Setscrew (A)
Setscrew (B)
Flexible flat cable
Setscrew (B)

Front cover

8
MODEL:eXperience 660
Setscrew (A)
Connector for printed
circuit board F
Setscrew (C)